Fuji Xerox DocuPrint P255 dw User Manual page 99

Manual Wi-Fi Setup
You can manually configure wireless settings to connect your printer to an access point
(infrastructure) network or computer-to-computer (ad-hoc) network.
• Connecting to Access Point Network
To configure the wireless settings through an access point such as a wireless router:
1
On the operator panel, press the
2
Select Admin Menu, and then press the
3
Select Network, and then press the
4
Select Wi-Fi Setup, and then press the
5
Select the desired access point, and then press the
If the desired access point does not appear:
Select Manual Setup, and then press the
a
Enter the SSID, and then press the
b
Use the or
cursor.
Select Infrastructure, and then press the
c
Select an encryption type, and then press the
d
IMPORTANT:
• Be sure to use one of the supported encryption methods from Mixed Mode PSK, WPA-PSK-TKIP,
WPA2-PSK-AES and WEP to protect your network traffic.
6
Enter the WEP key or pass phrase, and then press the
Use the or
When the encryption type is WEP, select a transmit key from Auto, WEP Key 1, WEP Key 2,
WEP Key 3, and WEP Key 4 after entering the WEP key.
7
Wait a few minutes until the printer restarts to establish the wireless network.
8
Print a System Settings page from the operator panel.
Press the
a
Select Report/List, and then press the
b
Select System Settings, and then press the
c
The System Settings page is printed.
9
Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.
NOTE:
• When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.
• If the wireless setting does not work, contact your system administrator or Fuji Xerox Customer Support
Center.
(Menu) button.
button to enter the desired value, and press the
button to enter the desired value, and press the
(Menu) button.
button.
button.
button.
button.
button.
button.
button.
button.
button.
button.
button.
Printer Connection and Software Installation
or button to move a
or button to move a cursor.
99