Connection Specifications; Grounding; Phase Adder; Thermal Overload Protector - Alliance Laundry Systems F232135R12 Installation Manual

Connection Specifications

IMPORTANT: Connection must be made by a
qualified electrician using wiring diagram provided
with machine, or according to accepted European
standards for CE-approved equipment.
Connect machine to an individual branch circuit not
shared with lighting or other equipment. Shield
connection in a liquid-tight or approved flexible
conduit. Copper conductors of correct size must be
installed in accordance with National Electric Code
(NEC) or other applicable codes.
Use wire sizes indicated in the Electrical
Specifications chart for runs up to 50 feet (15 m). Use
next larger size for runs of 50 to 100 feet (15 to 30 m).
Use two sizes larger for runs greater than 100 feet
(30 m).

Grounding

For personal safety and proper operation, the machine
must be grounded in accordance with state and local
codes. If such codes are not available, grounding must
conform to the National Electric Code, article 250
(current edition). The ground connection must be
made to a proven earth ground, not to conduit or water
pipes.
Do not connect ground to neutral (N-white wire) leg at
terminal strip.
F232135R12
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Phase Adder

If three-phase service is unavailable for a 2 speed
model and a Roto-Phase or other phase adder is used,
connect artificial leg to L3 in input power junction
box.
IMPORTANT: Do not use a phase adder on any
variable-speed machine.

Thermal Overload Protector

Two speed machines have thermal overload protectors
in drive motor windings and a separate fuse for control
circuit.
For variable-speed machines, the AC drive provides
overload protection for the drive motor.
Installation
61