Pump Drain Connection - Alliance Laundry Systems F232135R12 Installation Manual

Installation

Pump Drain Connection

NOTE: This is for models with a pump drain
option only.
The standpipe or drain receptacle must be capable of
handling a minimum of 1.5 inches (3.8 cm) outside
Recommended
diameter drain hose. Refer to Figure 40. The drain
Standpipe
hose should fit loose within the standpipe (it should
Height
36 in. (min)
not be a snug fit). Never install the drain hose into a
(92 cm)
"sealed" drain system as air cannot escape and will
restrict the water from being drained from the washer.
A sealed drain system may also allow water to be
siphoned back into the washer. Both of these
conditions may result in flooding of the washer.
CHM2088N
Figure 40
57
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
F232135R12