Installation; Machine Foundation - Alliance Laundry Systems F232135R12 Installation Manual

Machine Foundation

NOTE: Do not mount on wooden floors, tile floors,
above ground level, or over basements or crawl
spaces because of the high extract speed and the
G-forces exerted.
Thoroughness of detail must be stressed with all
foundation work to ensure a stable unit installation,
eliminating possibilities of excessive vibration during
the extract cycle.
The floor must be 3500 psi minimum reinforced
concrete set firmly in clean, compacted fill dirt.
Models
2 Speed and Fixed-Speed
(20-60 Models)
Variable-Speed
(20-60 Models)
Variable- 80 Models
Speed
125 Models
24

Installation

Machine Foundation Requirements
Foundation Floor
Thickness Thickness
4 in. 4 in.
(102 mm) (102 mm)
6 in. 6 in.
(152 mm) (152 mm)
9 in. 6 in.
(229 mm) (152 mm)
12 in. 6 in.
(304 mm) (152 mm)
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of fire, this appliance
must be bolted to an uncovered concrete
floor.
The machine must be anchored to a smooth, level
surface so that the entire base of the machine is
supported and rests on the mounting surface. (Do not
support the machine on only four points.) Grouting
is required.
An elevated foundation must not exceed 8 inches
(203 mm).
Refer to Table 1 for foundation and anchoring
requirements.
Installation
Foundation
Method(s)
Direct-to-finished-floor,
elevated base frame, or
concrete foundation
Direct-to-finished-floor,
elevated base frame
(A-control only),
or concrete foundation
Direct-to-finished-floor
or concrete foundation
Table 1
WARNING
Anchoring
Anchoring Bolt
Method(s) Diameter
Requirement Size
(minimum)
Expansion bolt, .63 in.
J-bolt, or
Adhesive
Anchor System
J-bolt, mounting .63 in.
bolt, or
Adhesive
Anchor System
J-bolt, mounting .75 in.
bolt, Adhesive
Anchor System,
or rebar frame
F232135R12
W743