Table of Contents
Advertisement
/maint/panic
Panic Command
The panic command causes the switch to immediately dump state information to flash mem-
ory and automatically reboot.
To select panic, at the Maintenance# prompt, enter:
>> Maintenance# panic
A FLASH dump already exists.
Confirm replacing existing dump and reboot [y/n]:
Enter
Confirm dump and reboot [y/n]: y
The following messages are displayed:
Starting system dump...done.
Rebooted because of PANIC command.
Booting complete
Version 1.3.0 from FLASH image1, active config block.
No POST errors (0xff).
Production Mode.
Unscheduled System Dumps
If there is an unscheduled system dump to flash memory, the following message is displayed
when you log on to the switch:
Note: A system dump exists in FLASH. The dump was saved
40M2420, April 2007
to confirm the command:
y
0:01:01 Tue Mar
at 13:43:22 Tuesday March 14, 2007. Use /maint/uudmp to
extract the dump for analysis and /maint/cldmp to
clear the FLASH region. The region must be cleared
before another dump can be saved.
Alteon OS Command Reference
14, 2007:
Chapter 9: The Maintenance Menu
351
Advertisement
Table of Contents
