Nortel Alteon OS 40M2420 Command Reference Manual page 189

Table 6-9 System SNMP Menu Options (/cfg/sys/ssnmp)
Command Syntax and Usage
snmpv3
Displays SNMPv3 menu. To view menu options, see
name <new string, maximum 64 characters>
Configures the name for the system. The name can have a maximum of 64 characters.
locn <new string, maximum 64 characters>
Configures the name of the system location. The location can have a maximum of 64 characters.
cont <new string, maximum 64 characters>
Configures the name of the system contact. The contact can have a maximum of 64 characters.
rcomm <new SNMP read community string, maximum 32 characters>
Configures the SNMP read community string. The read community string controls SNMP "get"
access to the switch. It can have a maximum of 32 characters. The default read community string is
public.
wcomm <new SNMP write community string, maximum 32 characters>
Configures the SNMP write community string. The write community string controls SNMP "set"
and "get" access to the switch. It can have a maximum of 32 characters. The default write commu-
nity string is private.
trsrc <1-128>
Configures the source interface for SNMP traps.
timeout <1-30>
Set the timeout value for the SNMP state machine, in minutes.
auth disable|enable
Enables or disables the use of the system authentication trap facility. The default setting is dis-
abled.
linkt <port> [disable|enable]
Enables or disables the sending of SNMP link up and link down traps. The default setting is
enabled.
cur
Displays the current SNMP configuration.
40M2420, April 2007
Alteon OS Command Reference
page 190.
Chapter 6: The Configuration Menu 189