Network Filter Configuration - Nortel Alteon OS 40M2420 Command Reference Manual

/cfg/l3/nwf

Network Filter Configuration

[IP Network Filter 1 Menu]
Table 6-66 IP Network Filter Menu Options (/cfg/l3/nwf)
Command Syntax and Usage
addr <IP address, such as 192.4.17.44>
Sets the starting IP address for this filter. The default address is 0.0.0.0.
mask <subnet mask, such as 255.255.255.0>
Sets the IP subnet mask that is used with /cfg/l3/nwf/addr to define the range of IP
addresses that will be accepted by the peer when the filter is enabled. The default value is 0.0.0.0.
For Border Gateway Protocol (BGP), assign the network filter to a route map, then assign the route
map to the peer.
enable
Enables the Network Filter configuration.
disable
Disables the Network Filter configuration.
delete
Deletes the Network Filter configuration.
cur
Displays the current the Network Filter configuration.
40M2420, April 2007
addr - IP Address
mask - IP Subnet mask
enable - Enable Network Filter
disable - Disable Network Filter
delete - Delete Network Filter
cur - Display current Network Filter configuration
Alteon OS Command Reference
Chapter 6: The Configuration Menu 261