Table of Contents
Advertisement
Alteon OS Command Reference
Setup Part 3: VLANs
If you chose to skip VLANs configuration back in Part 1, skip to
tion" on page
1.
Select the VLAN to configure, or skip VLAN configuration at the prompt:
VLAN Config:
Enter VLAN number from 2 to 4094, NULL at end:
If you wish to change settings for individual VLANs, enter the number of the VLAN you wish
to configure. To skip VLAN configuration, press <Enter> without typing a VLAN number and
go to
"Setup Part 4: IP Configuration" on page
2.
Enter the new VLAN name at the prompt:
Current VLAN name: VLAN 2
Enter new VLAN name:
Entering a new VLAN name is optional. To use the pending new VLAN name, press <Enter>.
3.
Enter the VLAN port numbers:
Define Ports in VLAN:
Current VLAN 2:
Enter ports one per line, NULL at end:
Enter each port, by port number or port alias, and confirm placement of the port into this
VLAN. When you are finished adding ports to this VLAN, press <Enter> without specifying
any port.
4.
Configure Spanning Tree Group membership for the VLAN:
Spanning Tree Group membership:
Current Spanning Tree Group index: 1
Enter new Spanning Tree Group index [1-127]:
5.
The system prompts you to configure the next VLAN:
VLAN Config:
Enter VLAN number from 2 to 4094, NULL at end:
Repeat the steps in this section until all VLANs have been configured. When all VLANs have
been configured, press <Enter> without specifying any VLAN.
38
Chapter 2: First-Time Configuration
39.
empty
"Setup Part 4: IP Configura-
39.
40M2420, April 2007
Advertisement
Table of Contents
