Nortel Alteon OS 40M2420 Command Reference Manual page 22

Alteon OS Command Reference
Figure 1-1 Switch management on the BladeCenter management module
4. You can use the default IP addresses provided by the management module, or you can
assign a new IP address to the switch module through the management module. You can
assign this IP address through one of the following methods:
Manually through the BladeCenter management module
Automatically through the IBM Director Configuration Wizard (available in
Director release 4.21)
N – If you change the IP address of the GbE Switch Module, make sure that the switch
OTE
module and the management module both reside on the same subnet.
22 Chapter 1: The Command Line Interface 40M2420, April 2007