Omron SYSMAC CP Series Instruction & Reference Manual page 112

2 Instructions
• When a TTIM(087)/TTIMX(555) timer is forced set, its Completion Flag will be turned ON and its PV
will be reset to 0. When a TTIM(087)/TTIMX(555) timer is forced reset, its Completion Flag will be
turned OFF and its PV will be reset to 0. The forced set and forced reset operations take priority over
the status of the timer and reset inputs.
• The timer's PV is refreshed only when TTIM(087)/TTIMX(555) is executed, so the timer will not oper-
ate properly when the cycle time exceeds 100 ms because the timer increments in 100-ms units.
• The timer's Completion Flag is refreshed only when TTIM(087)/TTIMX(555) is executed, so a delay of
up to one cycle may be required for the Completion Flag to be turned ON after the timer times out.
Sample program
When timer input CIO 0.00 is ON in the following example, the timer PV will begin counting up from 0.
Timer Completion Flag T0001 will be turned ON when the PV reaches the SV.
If the reset input is turned ON, the timer PV will be reset to 0 and the Completion Flag (T0001) will be
turned OFF. (Usually the reset input is turned ON to reset the timer and then the timer input is turned
ON to start timing.)
If the timer input is turned OFF before the SV is reached, the timer will stop timing but the PV will be
maintained. The timer will resume from its previous PV when the timer input is turned ON again.
ON
Timer input
0.00 OFF
Timer PV
T0001
Timer Completion
Flag
ON
T0001
OFF
ON
Reset input
OFF
2-76
0.00
TTIM
0001
0.01 #0100
#0100
0
0.00
TTIMX
0001
or
0.01 &0100
ON
OFF
#0100
0
ON
OFF
ON
OFF
CP1E CPU Unit Instructions Reference Manual(W483)
Timing resumes.
PV maintained.