Setting The Shutter Mode And Speed; Viewfinder Screen - Panasonic P2HD AJ-HPX3100G Operating Instructions Manual

Setting the Shutter Mode and Speed

The shutter speed in any shutter mode is set using the
SHUTTER switch.
In SYNCHRO SCAN mode, shutter speed can be switched
easily, using the SYNCHRO SCAN ADJUSTMENT switches
(+/–) on the side panel.
Note that the range of selectable shutter speeds may be pre-
defined; whether or not to use the SYNCHRO SCAN mode
may be determined through the <SHUTTER SPEED> and
<SHUTTER SELECT> screens.
> [CAM OPERATION] (page 181)
The selected shutter speed is retained even if the unit is
turned off.
# < SHUTTER SPEED >
SYNCHRO SCAN
POSITION1
POSITION2
POSITION3
POSITION4
POSITION5
POSITION6
# < SHUTTER SELECT >
POSITION1 SEL
POSITION2 SEL
POSITION3 SEL
POSITION4 SEL
POSITION5 SEL
POSITION6 SEL
Placing the Camera-recorder in SYNCHRO SCAN Mode
Press the SHUTTER switch positioned at [ON] towards
[SEL], to place the camera-recorder in SYNCHRO SCAN
mode.
In the SYNCHRO SCAN mode, it is possible to change the
shutter speed continuously by operating the SYNCHRO
SCAN (+/–) buttons.
The shutter speed display in synchro scan mode is
switchable between second indication and angle
indication.
> [SYNCHRO SCAN DISP.] (page 177)
Adjustments and Settings for Recording : Setting the Electronic Shutter
54
:ON
:ON
:ON
:ON
:ON
:ON
:ON
:1/100
:1/120
:1/250
:1/500
:1/1000
:1/2000
1
Press the SHUTTER switch, positioned at
[ON], towards [SEL].
SHUTTER switch
2
Once more, press the SHUTTER switch
towards [SEL]. Repeat this switchover until
the desired mode or speed appears in the

viewfinder screen.

If all modes and speeds are available, the display
changes in the following order:
NORMAL mode
POSITION1 POSITION2 POSITION3
Viewfinder displays relating to the shutter
See [Viewfinder Screen Status Displays] (page 75).
Note
SHUTTER mode turns off when operating the DS.GAIN.
SYNCHRO SCAN ADJUSTMENT buttons (+/–)
SHUTTER switch
POSITION4 POSITION5 POSITION6
SYNCHRO
SCAN mode