Table of Contents
Advertisement
Attaching the F.AUDIO LEVEL control Knob
If you use the F.Audio Level control frequently, attach the
accessory knob so that it can be easily operated.
Remove the screw in the center of the F.Audio Level control,
and attach the accessory knob using the screw (included).
When attaching the knob, be sure to align the marks on the
control with the marks on the knob.
Connection of the DC OUT connector and the
external REC strat/stop switch
It is possible to draw 1.5 A current from the DC OUT
connector of the unit.
REC start/stop can be controlled by connecting an external
switch to this connector.
Since a tally lamp can be used by connecting an LED to this
connector, it is useful for shooting video when fixing the
camera on a crane.
DC OUT connector
F.Audio
Level Control
Marks
Screw
(Reference connection example)
4
1
3
2
LED
Resistance
REC start/stop
1: GND
2: TALLY OUT
Open collector output on the unit side
TALLY ON:
Low impedance
TALLY OFF:
High impedance
3: REC start/stop switch (DC 11 V - 17 V)
This is connected in parallel to the REC START button on the
unit or the VTR button on the lens
4: 12 V
Note
Ensure that polarity is correct before connecting an external
device, as failure to do so may result in damage.
Preparation: Attaching the F.AUDIO LEVEL control Knob
Knob
(Accessory)
Screw
(Accessory)
Connector at the cable side
HR10A-7R-4P(73)
(Hirose Denki)
> [Connector Signals]
(page 149)
117
Advertisement
Table of Contents
