Panasonic P2HD AJ-HPX3100G Operating Instructions Manual page 140

Writing data on a hard disk drive
1
Switch the mode to USB HOST.
> [Switching to the USB HOST mode] (page 137)
2
Connect a hard disk drive via USB.
A hard disk drive that has not been formatted with the
camera-recorder must be formatted as directed in
[Formatting a hard disk drive] (page 139).
3
Insert a P2 card.
4
Press the THUMBNAIL button.
The thumbnail screen is displayed.
5
Press the THUMBNAIL MENU button and
select HDD > EXPORT from the thumbnail
menu.
Specify the slot that contains the P2 card bearing the
data to be written to the hard disk drive.
6
Select YES.
This starts the write process.
When the data is being written, a progress bar is
displayed. To diskontinue writing, press the SET
button and select YES instead of cancellation
confirmation.
When the writing is completed, the message "COPY
COMPLETED!" is displayed.
Notes
To disable verification at the time of writing, select HDD
> SETUP from the thumbnail menu and set the option
VERIFY to OFF. This speeds up writing without
verifying data writing.
Select "ALL SLOT" to write data collectively onto all P2
cards currently inserted in the unit to the hard disk
drive.
Notes
For a Type-S hard disk drive, data can be written on a card
basis. The data on up to 23 P2 cards can be stored on the
hard disk drive. The data set on each P2 card is recognized
as a separate drive by the PC.
If data on a P2 card that contains a defective clip must be
written to a hard disk drive, then we recommend fixing that
clip before writing the data.
When the process is diskontinued during verification, the
data on the P2 card has been written to the hard disk drive.
140
Connection with external device: Connection with external devices using the USB 2.0 port
Writing data back to P2 cards
You can select clips on the hard disk drive to be written back
to P2 cards.
1
Switch the mode to USB HOST.
> [Switching to the USB HOST mode] (page 137)
2
Connect a hard disk drive via USB.
3
Insert the target P2 card in a slot.
4
Press the THUMBNAIL MENU button and
select HDD > EXPLORE from the thumbnail
menu. Move to the appropriate partition and
select it with the SET button.
5
From among the thumbnails, select the clips
to be written to the P2 card.
6
Press the THUMBNAIL MENU button and
select OPERATION > COPY. Then, specify the
slot that contains the target P2 card.
7
Select YES.
This starts the data write to the P2 card.
When the writing is completed, the message "COPY
COMPLETED!" is displayed.
Notes
When only selected files are written, no verification is
performed.
Import data in clip units from cards with a different model
number as data cannot be imported by the partition between
such cards.
For a Type-S or P2 STORE hard disk drive, you can write
data back to a P2 card with the same model number on a
card basis. The target P2 cards must be preformatted.
1
Switch the mode to USB HOST.
> [Switching to the USB HOST mode] (page 137)
2
Connect a hard disk drive via USB.
3
Insert the target P2 cards in slots.
4
Press the THUMBNAIL MENU button and
select HDD > EXPLORE. Then, move to the
appropriate partition and select it with the SET
button.
5
From the thumbnail menu, select OPERATION
> IMPORT. Then, specify the slots that
contain the empty target P2 cards.