Table of Contents
Advertisement
Use of the external DC power supply
1
Connect the external DC power supply to the
DC IN socket on the unit.
External DC
power supply
2
Turn "ON" the power switch of the external DC
power supply.
(If the power switch is available on the external DC
power supply)
3
Turn ON the POWER switch on the unit.
Inrush current is generated when the power of the
unit is turned on. Insufficient power supply when
turning on the power may cause a malfunction. We
recommend using an external DC power supply with
double the capacity of the total power consumption
of the unit and any other connected device that is
turned by interlocking with the power on of the unit
(the viewfinder). For the DC cord, please use a dual-
core, balanced type shielded wire of at least AWG18
gauge (nominal cross section 0.824 mm
Confirm the pin arrangements of the DC output
connector of the external DC power supply and the
DC IN socket on the unit, and connect the proper
polarities to each other.
If the 12 V power supply is connected to the GND
connector in error, it may cause a fire or failure of
the unit.
4
1
2
3
DC IN Socket
110
Preparation: Power Supply
DC IN Socket
2
).
Pin No.
Signal
1
GND
—
2, 3
4
+12V
CASE
FRAME GND
Notes
If both the battery pack and the external DC power
supply are connected, the electric power is supplied
from the external DC power supply. While the external
DC power supply is used, the battery can be mounted
and removed on/from the unit.
When the external DC power supply is used, ensure
that the power switch of the external DC power supply
is turned on first and then the POWER switch on the
unit is turned on. In the case of the reverse operation, a
malfunction may occur on the unit since the output
voltage of the external DC power supply is raised
slowly.
When using a power supply from the DC IN socket, the
light circuitry will not operate. The light circuitry can
only be operated when powered from an Anton/Bauer
battery plate.
Advertisement
Table of Contents
