Toshiba TOSVERT VF-MB1/S15 IPE002Z Function Manual page 44

For tosvert vf-mb1/s15
Hide thumbs Also See for TOSVERT VF-MB1/S15 IPE002Z:
Table of Contents

Advertisement

Instance 2 Attribute
Instance
Attribute ID Access
1
Get
2
Get
2
3
Get
6
Get/Set
7
Get
10
Get
Note: Don't use the "System reserved" bit and Bit0 for the judgement.
Instance Services
Service Code
Service Name
0x01
Get_Attribute_All
0x0E
Get_Attribute_Single
0x10
Set_Attribute_Single
0x4C
Get_and_Clear
Name
Data type Details
Interface Speed
UDINT
Interface Flags
DWORD
Physical Address
ARRAY of
6 USINTs
Interface Control
STRUCT
of
Control Bits
WORD
Forced Interface
UINT
Speed
Interface Type
USINT
Interface Label
SHORT_S
TRING
Read all attributes
Read one attribute
Write one attribute
Gets then clears the specified attribute
(Interface Counters or Media Counters).
- 43 -
Interface speed currently in use
0: indeterminate (Auto baudrate)
10: 10Mbps
100: 100Mbps
Bit 0: Link Status Indicates whether or not the
Ethernet 802.3 communications
interface is connected to an active
network. 0 indicates an inactive link; 1
indicates an active link.
Bit 1: Half/Full Duplex Indicates the duplex
mode currently in use. 0 indicates the
interface is running half duplex; 1
indicates full duplex.
Bit 2-4: Negotiation Status
000 : Auto-negotiation in progress.
001 : Auto-negotiation and speed detection
failed.
010 : Auto negotiation failed but detected
speed. Duplex was defaulted.
011 : Successfully negotiated speed and
duplex.
100 : Auto-negotiation not attempted. Forced
speed and duplex.
Bit 5: Manual Setting Requires Reset. 0
indicates the interface can activate
changes to link parameters
(auto-negotiate, duplex mode, interface
speed) automatically. 1 indicates the
device requires a Reset service be
issued to its Identity Object in order for
the changes to take effect.
Bit 6: Local Hardware Fault.
0 indicates the interface detects no local
hardware fault
1 indicates a local hardware fault is
detected. The meaning of this is
product-specific.
(System reserved)
Bit 7-31
MAC layer address
Configuration for physical interface
Interface Control Bits
Speed at which the interface shall be forced to
operate
Type of interface: twisted pair, fiber, internal,
etc.
Human readable identification
5, Right
Description of Service
E6581741

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ethernet/ip modbus ipe002z

Table of Contents