Alarm Lamp Flashes Orange - Canon iP3600 SERIES On-Screen Manual

Alarm Lamp Flashes Orange

>
Advanced Guide Troubleshooting
Alarm Lamp Flashes Orange
When a printer error occurs, the Alarm lamp flashes orange as shown below. The number of flashes
indicates the type of error that has occurred. Count the flashes and take the appropriate action to correct
the error.
(A) Note the number of flashes
(B) Flashes repeatedly
Number of flashes/Cause
Two flashes:
Printer is out of paper. /Paper does not
feed.
Three flashes:
Paper Output Tray is closed./Paper jam.
Four flashes:
Ink tank is not installed properly./Ink
may have run out.
Five flashes:
Print Head is not installed./Print Head is
defective.
Seven Flashes:
Ink tank is not installed in the correct
position.
Eight flashes:
Ink absorber is almost full.
> Alarm Lamp Flashes Orange
Reload paper in the Rear Tray or Cassette and press the
RESUME/CANCEL
If the Paper Output Tray is closed, open it. The printer
resumes printing.
If opening the Paper Output Tray does not resolve the
problem, or if the tray was open to begin with, the paper may
be jammed. Remove the jammed paper, reload paper
properly in the printer, then press the
button on the printer.
Paper Jams
If the lamp on the ink tank is not lit, the ink tank may not
be installed properly.
Install an appropriate ink tank.
If the lamp on the ink tank is flashing, ink may have run
out.
Replacing the ink tank is recommended.
If printing is in progress and you want to continue printing,
press the
RESUME/CANCEL
Then printing can continue. Replacing the ink tank is
recommended after the printing. The printer may be
damaged if printing is continued under the ink out condition.
Routine Maintenance
Note
If multiple ink lamps are flashing, refer to
Maintenance
Follow the directions given in your setup manual to install the
Print Head.
If the Print Head is already installed, remove the Print Head
once and then reinstall it.
If the error is still not resolved, the Print Head may be
damaged. Contact your Canon service representative.
Some ink tanks are not installed in the correct position.
(The lamps on the ink tanks flash.)
More than one ink tanks of the same color are installed.
(The lamps on the ink tanks flash.)
Confirm that the ink tanks are installed in the appropriate
positions.
Routine Maintenance
The ink absorber is becoming full.
The printer has a built-in ink absorber to hold the ink used
during Print Head Cleaning.
Press the
RESUME/CANCEL
the error so you can continue printing. Before the ink
Action
button on the printer.
RESUME/CANCEL
button with the ink tank installed.
and confirm the status of each ink tank.
button on the printer to cancel
Стр. 297 из 366 стр.
Routine