Printing Does Not Start - Canon iP3600 SERIES On-Screen Manual

Printing Does Not Start

>
Advanced Guide Troubleshooting
Printing Does Not Start
Check 1: Make sure that the power plug is securely plugged in, then
turn the printer on.
While the Power lamp is flashing green, the printer is initializing. Wait until the Power
flashing and remains lit green.
Note
When printing large data such as a photo or graphics, it may take longer to start printing. While
the Power lamp is flashing green, the computer is processing data and sending it to the
printer. Wait until printing starts.
Check 2: Check the status of ink tanks. Replace the ink tank if ink has
run out.
Check 3: Open the Top Cover and check to see if the ink lamps are
flashing red.
If there is still sufficient ink but its ink lamp is flashing red, an ink tank may not be installed in a right
position.
Routine Maintenance
Check 4: Open the Top Cover and make sure that the ink lamps light up
red.
If the ink lamp is not lit, press the
Check 5: Make sure that the USB cable is securely plugged in to the
printer and the computer, then check the following:
If you are using a relay device such as a USB hub, disconnect it, connect the printer directly to
the computer, and try printing again. If printing starts normally, there is a problem with the relay
device. Consult the reseller of the relay device for details.
There could also be a problem with the USB cable. Replace the USB cable and try printing
again.
Check 6: Restart your computer if you are printing from the computer.
If there are any unnecessary print jobs, delete them.
Deleting the Undesired Print Job
Check 7: Make sure that your printer's name is selected in the Print
dialog box.
The printer will not print properly if you are using a driver for a different printer.
In Windows, make sure that your printer's name is selected in the Print dialog box.
On a Macintosh, make sure that your printer's name is selected in Printer in the Print dialog box.
Note
To make the printer the one selected by default, select Set as Default Printer (Windows),
Default Printer (Mac OS X v.10.5.x), or Make Default (Mac OS X v.10.4.x or Mac OS X v.10.3.9).
Check 8: Configure the printer port appropriately.
> Printing Does Not Start
mark on the ink tank until it clicks into place.
Стр. 317 из 366 стр.
lamp stops