Milling; Feed - Proxxon FF 500 CNC Commissioning Manual

12.6. Milling

Caution!
8
Always wear protective goggles during milling.
Comply with the safety regulations without fail!
The work piece to be processed must always be
securely fastened to the cross table! There are
various possibilities available to you: Clamping
jaws (e.g. 24 257 from PROXXON) and vices (e.g.
24 255 from PROXXON) are very well suited. The
cross section of the groove is shown in the image
on the right.
You will find examples for clamping devices and
accessories in our equipment brochure, on the
13,5
internet at www.proxxon.com, and together with
other valuable notes, in our "Manual for the Creative Modeller" (Art. No. 28 996; only
in German).

12.7. Feed:

During milling, make sure the feed always occurs against
the cutting direction of the milling cutter, see image at right.
32 of 55