Emergency Stop / Lock - Proxxon FF 500 CNC Commissioning Manual

8.6. EMERGENCY stop / lock

The EMERGENCY stop is used to lock the CNC milling machine
for command receipt and for command execution. Only the red
status lamp will light up in the "Lock" (Sperren) position. The lock
can be useful, for example, to prevent the execution of a
movement command that was entered unintentionally.
The lock is removed when the switch is set to "On" (Ein) and the
CNC milling cutter is ready for operation again. This is signalled by
the glowing green light.
19 of 55