Drives Of The Tool Axes; Software And Stepping Motor Controllers - Proxxon FF 500 CNC Commissioning Manual

5.2. Drives of the tool axes

Spindle drive X axis
(Longitudinal drive, cross table):
Spindle drive Y axis
(Transverse drive, lower carriage):
Spindle drive Z axis
(Leading spindle, longitudinal drive,
support):

5.3. Software and stepping motor controllers

Power supply
Power consumption
Gate
Stepping motor controller
Recirculating ball screw with 4 mm pitch, effective
diameter 12 mm. Stepping motor 2.2 A, holding torque
1.27 Nm, traverse path: approx. 290 mm
Recirculating ball screw with 4 mm pitch, effective
diameter 12 mm. Stepping motor 2.2 A, holding torque
1.27 Nm, traverse path: approx. 100 mm
Recirculating ball screw with 4 mm pitch, effective
diameter 12 mm. Stepping motor 2.2 A, holding torque
1.27 Nm, traverse path: approx. 220 mm
Input: 230 Volt +-5%
Mains unit: output 35 V (included)
min 150 Watt
Serial interface
Through CNC control unit (included) current control,
pulse width modulation
Current reduction during standstill, clocking independent
of PC, microstepping
- Connection cable to PC included
11 of 55