Compilation Of Safety Notes - Proxxon FF 500 CNC Commissioning Manual

17. Compilation of safety notes:

As with any other machine, there are some things that need to be observed when
operating the CNC milling machine so that dangers to humans and the environment
cannot occur.
In this context, please also observe the separately enclosed pamphlet with the safety
notes.
Special noise protection
User group
Caution!
Risk of injuries!
Setting up the
workplace:
User group
Machining unit
Changing work pieces
When changing the tools, the mains power input for the machining unit must be
removed from the mains socket!
Clamp the milling cutter as short as possible!
Eye and
contact protection
This can be achieved through ear protection, a protective
cell, or a closed room. Also, clamp the tools short so that
they do not vibrate so strongly
Persons above the age of 14 may use the system;
instructions on safety and compliance with the safety
notes is always required.
Always keep your fingers away from the rotating work
piece during milling! Never measure the work piece during
operation with a sliding calliper or similar device! Do not
process the work piece during operation with a rasp or
sandpaper!
No spatial narrowness
EMERGENCY Off pushbutton in the room
Vacuum cleaner, permanently installed
PC and machine next to each other
Technically capable persons who are at least 14 years of
age.
Familiarize yourself using the documents or by being
instructed.
Due to the safety regulations, a machining unit for
clamping processing is delivered.
Please observe at all costs that the machine is protected
against unintentional actuation while changing the tools or
clamping work pieces in the respective clamping device!
Wear protective goggles in the immediate vicinity and
make sure that the chuck guard is in the correct position
when operating the machine.
41 of 55