Qos Option Settings; Secondary Ethernet (Hub)/Ir Interface Enable/Disable - Avaya IP Office 3.0 Installation Manual

IP Office IP Phone Installation Manual

QoS Option Settings

Administering QoS options is not mandatory, but it is highly recommended. Use the following procedure
to set Quality of Service (QoS) options.
1. While the phone is on-hook and idle, press the following sequence: Hold 7 6 7 # (Hold Q O S #).
The current 802.1Q setting is shown.
2. The phone displays L2 audio=. This is the phone's current 802.1 audio parameter. Press # to
accept the current value or enter a value (between 0 and 7) and then press #.
3. The phone displays L2 signaling=. This is the phones 802.1 signaling parameter. Press # to
accept the current value or enter a value (between 0 and 7) and then press #.
4. The phone displays L3 audio=. This is the phone's Differential Services audio parameter. Press
# to accept the current value or enter a value (between 0 and 63) and then press #.
5. The phone displays L3 signaling=. This is the phone's Differential Services signaling parameter.
Press # to accept the current value or enter a value (between 0 and 63) and then press #.
6. If no new values were entered during this procedure, the phone displays No new values. Press #
to end the procedure.
7. If new values were entered during this procedure, the phone displays Save new values?. Press
* to end the procedure or # to save the new values.
8. If you press #, the phone displays New values being saved and then returns to normal
operation.

Secondary Ethernet (Hub)/IR Interface Enable/Disable

Use the following procedure to enable or disable the hub interface found on some Avaya IP phones
(usually marked with a
The same procedure can also be used to enable or disable the IR port found on some Avaya IP phones,
see Infrared Dialing for more details.
1. While the phone is on-hook and idle, press the following sequence: Hold 4 6 8 # (Hold I N T #)
2. The phone displays PHY2= and its current setting. This is the PC connection LAN socket marked
as on the telephone.
3. Press 1 or 0 to enable or disable the hub interface respectively. Press # to continue.
4. The phone displays IR= and its current setting. This is the infrared (IR) port located on the front of
some Avaya IP telephones.
5. Press 1 or 0 to enable or disable the hub interface respectively. Press # to continue.
6. If you changed the setting, Save new values? is displayed. Press * to end the procedure or # to
save the new values.
7. If you press #, the phone displays New values being saved and then returns to normal
operation.
Avaya IP Phone Installation
IP Office 3.0
symbol). The default for the hub interface is enabled.
Issue 10b (26th January 2005)
Page 22