Table of Contents
Advertisement
switch. If the Test light does not go on, the voice terminal may not have
power. In this case, check the connections and then verify that the
particular voice terminal is administered on the DEFINITY switch.)
Adjusting the 8405 and 8410 Voice Terminal Desktop Stand
To provide better display visibility on the 8405D, 8405D Plus, and 8410D set,
the desktop stand on these terminals can be installed in a high or low
position. (When the voice terminal is shipped from the factory, the stand is in
the low position.) Figure 5 shows you the set of tabs to use for each position.
NOTE: On the 8411 voice terminal, you can lift the kickstand on the back of
the set to provide a better viewing angle of the terminal display.
Check which position (either the position of the desktop stand or the
kickstand, according to the type of voice terminal you are using) allows the
user the best viewing angle of the display, and then use the following short
procedure for installing the desktop stand in the selected position.
To reinstall the desktop stand on the 8405D, 8405D Plus, or 8410D voice
terminal for the low or the high position (See Figure 5.)
1. Place the lower desktop stand tab in the appropriate voice terminal tab
slot.
2. Slowly lower the desktop stand until the top tab fits into the appropriate
tab slot at the top of the voice terminal. You may need to press inward on
the top of the desktop stand (see Figure 5) in order for the tab to fit into
the slot.
NOTE: As noted before, if you choose to install the desktop stand in the
high position, you may need to pass the cords through the long,
rectangular opening that surrounds the jacks and then plug the cords
into the jacks BEFORE you place the stand on the back of the voice
terminal.
15
Advertisement
Table of Contents
