Enabling/Disabling The Status Lights For The Analog (Tip/Ring) Adjunct Interface (For The 8411 Only) - Lucent Technologies 8400 Series Installation And User Manual

Voice terminals
Hide thumbs Also See for 8400 Series:
Table of Contents

Advertisement

To select which channel (the I-1 Channel or the I-2 Channel) the Analog
(T/R) Adjunct will use
1. While on-hook, press
The light next to
Mute
2. Press
The light next to
3. Enter the 2-digit code, "42" ("IC").
The red light next to
The current setting (either T/R ON I1 CHANNEL or T/R ON I2
CHANNEL) is shown on the display, if there is one.
4. Press either "1" or "2" to change the setting:
Press "1" to select the I-1 Channel for Analog Adjunct transmission
Press "2" to select the I-2 Channel for Analog Adjunct transmission
or if the voice terminal has a display, press
setting. Press
programming.
After pressing "1" or "2" or pressing
goes off and one of the following voice terminal responses occurs:
If the voice terminal saves your selection, the first three green call
appearance lights go on and, if you have a display, a confirmation
message is displayed.
If the voice terminal cannot save this selection, the first three red
call appearance lights go on and, if you have a display, an error
message is displayed. In this case, the selected option will be in
effect until power is removed from the set. If this happens, try
repeating the process. If the option still cannot be saved, the
terminal may be faulty.
Enabling/Disabling the Status Lights for the Analog (Tip/Ring)
Adjunct Interface (For the 8411 Only)
If an Analog Adjunct has been connected to the Analog Adjunct jack on the
rear of the 8411 voice terminal, the user can use the lights next to Button #10
(the last button in the second column) to see the status of the Analog Adjunct
connection. These indications show:
Status of the ringing signal being sent from the voice terminal to the
Analog Adjunct) (on OR off)
Switchhook status of the Analog Adjunct (off-hook OR on-hook and idle)
Status of the I-Channel (used by the Analog Adjunct OR by the 8411 voice
terminal)
Shift
.
Shift
goes on.
.
Shift
goes off.
Shift
#
to save the desired option and then exit
flutters.
#
, the light next to
28
to change the
*
Shift

Advertisement

Table of Contents
loading

This manual is also suitable for:

84038405841084118434dx

Table of Contents