Table of Contents
Advertisement
For a more detailed list of Analog Adjunct (Tip/Ring) status light indications,
see "PassageWay and Analog Adjunct Status Indications on the 8411" earlier
in this manual.
To enable or disable the status lights for the Analog Adjunct interface
1. While on-hook, press
The light next to
Mute
2. Press
The light next to
3. Enter the 2-digit code, "25" ("AL").
The red and green lights next to Button #10 flutter.
The current setting (ENABLE T/R STATUS LAMPS or
DISABLE T/R STATUS LAMPS) is shown on the display, if there is
one.
4. Press either "1" or "2" to change the setting:
Press "1" to enable the status lights for the Analog (Tip/Ring) Adjunct
connected to the Analog Adjunct jack
Press "2" to disable status lights for Analog Adjunct connection (so
the button is thus used in the normal way, that is, for call appearance
or feature indications)
or if the voice terminal has a display, press
setting. Press
programming.
After pressing "1" or "2" or pressing
goes off and one of the following voice terminal responses occurs:
If the voice terminal saves your selection, the first three green call
appearance lights go on and, if you have a display, a confirmation
message is displayed.
If the voice terminal cannot save this selection, the first three red
call appearance lights go on and, if you have a display, an error
message is displayed. In this case, the selected option will be in
effect until power is removed from the set. If this happens, try
repeating the process. If the option still cannot be saved, the
terminal may be faulty.
Shift
.
Shift
goes on.
.
Shift
goes off.
#
to save the desired option and then exit
#
, the light next to
29
to change the
*
Shift
Advertisement
Table of Contents
