Table of Contents
Advertisement
WARNING: Do not insert the handset cord into the Adjunct jack. It may
cause equipment damage.
9. Snap the free end of the 1-foot line cord into the wall jack.
10. Place the base of the voice terminal on the wall-jack mounting studs,
and pull downward until it is secure, as shown in Figure 8.
Wall jack
FIGURE 8:
Placing the Voice Terminal onto the Wall Jack Mounting Studs
11. Snap the free end of the handset cord into the handset and place the
handset in the cradle.
NOTE: The handset hook you repositioned will hold the handset in
place.
12. Lift the handset and listen for dial tone. If there is no dial tone, check all
wire connections to make sure they are secure. Also, perform a self-test
to see if the terminal is receiving power. (Press and hold down the
Test
button. If the light next to the button flashes rather than goes on
steadily, it means the terminal is not able to communicate with the
switch. If the Test light does not go on, the voice terminal may not have
power. In this case, check the connections and then verify that the
particular voice terminal is administered on the DEFINITY switch.)
19
Advertisement
Table of Contents
