Table of Contents
Advertisement
Enabling/Disabling the Status Lights for the PassageWay
Connection (For the 8411 Only)
If a PC for the PassageWay Solution has been connected to the
RS-232-D jack on the rear of the 8411, the user can use Button #9 (the
next-to-last button in the second column) to see the status of the
PassageWay connection. For a list of PassageWay indications, see
"PassageWay and Analog Adjunct Status Indications on the 8411" earlier in
this manual.
To enable or disable the status lights for the PassageWay connection
1. While on-hook, press
The light next to
Mute
2. Press
The light next to
3. Enter the 2-digit code, "79" ("PW").
The red and green lights next to Button #9 flutter.
The current setting (ENABLE PWY STATUS LAMPS or DISABLE
PWY STATUS LAMPS) is shown on the display, if there is one.
4. Press either "1" or "2" to change the setting:
Press "1" to enable the status lights for the PassageWay connection
(next to Button #9)
Press "2" to disable the status lights for the PassageWay connection
or if the voice terminal has a display, press
setting. Press
programming.
After pressing "1" or "2" or pressing
goes off and one of the following voice terminal responses occurs:
If the voice terminal saves your selection, the first three green call
appearance lights go on and, if you have a display, a confirmation
message is displayed.
If the voice terminal cannot save this selection, the first three red
call appearance lights go on and, if you have a display, an error
message is displayed. In this case, the selected option will be in
effect until power is removed from the set. If this happens, try
repeating the process. If the option still cannot be saved, the
terminal may be faulty.
Shift
.
Shift
goes on.
.
Shift
goes off.
#
to save the desired option and then exit
#
, the light next to
30
to change the
*
Shift
Advertisement
Table of Contents
