Table of Contents
Advertisement
Lucent Technologies
MADE IN U.S.A.
Expansion
module jack
NOTE: The location of the jacks and the routing channel
on the back of your voice terminal may differ slightly
from the location shown in this figure.
FIGURE 4:
Line, Adjunct, Handset, and Expansion Module Cord Routing on the
8434DX Voice Terminal
7. Turn the voice terminal right side up, with the front facing you.
8. Snap the free end of the handset cord into the handset and place the
handset in the cradle.
9. Snap the free end of the line cord into the modular wall jack.
Refer to the section, "Attaching Adjunct Equipment" for information
about connecting an 8400-Series voice terminal to the wall jack when an
adjunct is used.
10. Lift the handset and listen for dial tone. If there is no dial tone, check all
wire connections to make sure they are secure. Also, perform a self-test
to see if the terminal is receiving power. (Press and hold down the
Test
button. If the light next to the button flashes rather than goes on
steadily, it means the terminal is not able to communicate with the
Routing channel
USE ONLY WITH
!
COMMUNICATION
CIRCUIT POWER
SOURCE
LISTED
U L
Telephone
®
Equipment
91B0
Handset
jack
LINE
EX MOD
HAC
> ABS<
14
Line jack
Adjunct
jack
Advertisement
Table of Contents
