4.6.2 RSTP Port Configuration
The RSTP Port Configuration page contains fields for assigning RSTP properties to individual ports. The screen in Figure
4-25 appears.
The page includes the following fields:
• Port
• Aggregations
• Protocol Enabled
• Edge
• Path Cost
4.6.3 RSTP Status
The RSTP Status page display the current STP bridge , roor bridge and per port stp status.
Figure 4-25 RSTP Port Configuration
Indicate port 1 to port 24.
Link Aggregation group setting, created by Port Trunk or LACP
Enables or disables RSTP protocol on the selected port.
Indicates whether the port is enabled as an edge port.
Edge port cannot create loops, but it loses edge port status if a topology change
creates a potential for a loop. An edge port normally should not receive BPDU
packets. If a BPDU packet is received it automatically loses edge port status
The port contribution to the root path cost. The path cost is adjusted to a higher or
lower value, and is used to forward traffic when a path being rerouted.
Value Rage : 1-20000000
Default Path Cost -- The default path cost of the port is automatically set by the
port speed and the default path cost method. The default values for path costs
are:
- Ethernet - 2000000
- Fast Ethernet - 200000
- Gigabit Ethernet - 20000
33