Configuration; Main Menu - Planet GSW-1602SF User Manual

The GSW-1602SF/2404SF Web Smart Gigabit Ethernet Switch provide Web interface for Switch smart function
configuration and make the Switch operate more effectively - They can be configured through the Web Browser. A
network administrator can manage and monitor the GSW-1602SF /2404SF from the local LAN. This section indicates how
to configure the Switch to enable its smart function.

4.1 Main Menu

After a successful login, the main screen appears, the main screen displays the Switch status. The screen in Figure 4-1
appears.
As listed at the left of the main screen, the configurable smart functions are shown as below:
System – Check the hardware, software version and System MAC address. Setting the IP address and SNMP
management for the switch.
Port Configuration - Setup per port Speed/Duplex mode, Flow Control and jumbo frame
Port Mirroring - dedicated port monitoring for incoming packets
VLANs – Configure VLAN Member / Port Configuration
Rapid Spanning Tree – Configure Rapid spanning tree topography for any arrangement of bridges. .
Link Aggregation – Port Trunk / LACP
IGMP Snooping - Enables or disables IGMP Snooping on the device to filter the multicast stream.
Quality of Service – Mapping the packet level to classify the packets priority.
802.1X Management – Specify ports with network access control.
MAC Address – Dynamic Address Table / Static MAC Address
Tools – Reboot / Factory Reset / Firmware Update / Configuration Upload / Ping / Cable Diagnostic

4. CONFIGURATION

Figure 4-1 Web Main screen
11