Rapid Spanning; Rstp System Configuration - Planet GSW-1602SF User Manual

4.6 Rapid Spanning

Spanning Tree Protocol (STP) provides tree topography for any arrangement of bridges. STP also provides one path
between end stations on a network, eliminating loops.
Rapid Spanning Tree Protocol (RSTP) - While Classic Spanning Tree guarantees preventing L2 forwarding loops in a
general network topology, convergence can take up to 30-60 seconds. The convergence time is considered too long for
many applications. When network topology allows, faster convergence may be possible. The Rapid Spanning Tree
Protocol (RSTP) detects and uses of network topologies that provide faster convergence of the spanning tree, without
creating forwarding loops.
The devices support the following Spanning Tree protocols:
‧ Compatiable -- Spanning Tree Protocol (STP):Provides a single path between end stations, avoiding and
eliminating loops.
‧ Normal -- Rapid Spanning Tree Protocol (RSTP) : Detects and uses of network topologies that provide
faster spanning tree convergence, without creating forwarding loops.
The GSW-1602SF/GSW-2404SF implement the Rapid Spanning Protocol as the default spanning
Note
:
tree protocol. While select "Compatibles" mode, the system use the RSTP(802.1w) to compatible
and co work with another STP(802.1d)'s BPDU control packets.
This page is to enable/disable the Spanning Tree protocol. The switch support IEEE 802.1d Spanning Tree (STP), IEEE
802.1w Rapid Spanning Tree (RSTP). The screen in Figure 4-23 appears.

4.6.1 RSTP System Configuration

The "RSTP System Configuration" table allows configuring the spanning tree parameters.
Figure 4-23 Rappid Spanning Tree System/Port Configuration
31