Install The Gsw-1602Sf/2404Sf; Desktop Installation; Rack Mounting - Planet GSW-1602SF User Manual

2.2 Install the GSW-1602SF/2404SF

This section describes how to install your GSW-1602SF/2404SF Web Smart Gigabit Ethernet Switch and make
connections to the switch. Please read the following topics and perform the procedures in the order being presented.
PLANET GSW-1602SF/2404SF Web Smart Gigabit Ethernet Switch do not need software configuration. To install your
GSW-1602SF/2404SF on a desktop or shelf, simply complete the following steps.

2.2.1 Desktop Installation

To install a GSW-1602SF/2404SF on a desktop or shelf, simply complete the following steps:
Step1: Attach the rubber feet to the recessed areas on the bottom of the switch.
Step2: Place the GSW-1602SF/2404SF on a desktop or shelf near an AC power source.
Step3: Keep enough ventilation space between the switch and the surrounding objects.
When choosing a location, please keep in mind the environmental restrictions discussed in Chapter
Note
1, Section 4, and Specification.
:
Step4: Connect your GSW-1602SF/2404SF to network devices.
Connect one end of a standard network cable to the 10/100/1000 RJ-45 ports on the front of the
A.
GSW-1602SF/2404SF
Connect the other end of the cable to the network devices such as printer servers, workstations or routers...etc.
B.
Connection to the Switch requires UTP Category 5 network cabling with RJ-45 tips. For more
Note
information, please see the Cabling Specification in Appendix A.
:
Step5: Supply power to the Switch.
Connect one end of the power cable to the GSW-1602SF/2404SF.
A.
Connect the power plug of the power cable to a standard wall outlet.
B.
When the GSW-1602SF/2404SF receives power, the Power LED should remain solid Green.

2.2.2 Rack Mounting

To install the switch in a 19-inch standard rack, follow the instructions described below.
Step1: Place your GSW-1602SF/2404SF on a hard flat surface, with the front panel positioned towards your front side.
Step2: Attach a rack-mount bracket to each side of the switch with supplied screws attached to the package. Figure 2-4
shows how to attach brackets to one side of the switch.
You must use the screws supplied with the mounting brackets. Damage caused to the parts by
Caution:
using incorrect screws would invalidate your warranty.
Figure 2-5 Attaching the brackets to the GSW-2404SF
6