Installing The Door - Trane Engineered Smoke Control System Application Manual

Chapter 4 Installing the Tracer Summit BMTX BCU
50

Installing the door

To install the enclosure door:
1. Unpack the door and check for missing or damaged parts.
Check to make sure that the magnetic latches are installed. Check for
any cracks in the plastic.
2. Hold the door at a 90° angle from the enclosure back as shown in Fig-
ure 23.
3. Align the hinge pegs on the door with the hinge holes on the enclo-
sure.
4. Gently lower the door until it rests securely in the hinge holes.
5. Verify that the door swings freely on the hinges and that the magnetic
latches hold the door securely when it is closed.
Figure 23. Installing the door
BAS-APG001-EN