Mounting The Back Of The Enclosure - Trane Engineered Smoke Control System Application Manual

Chapter 5 Installing the Tracer MP581 programmable controller
58

Mounting the back of the enclosure

The back of the enclosure is shipped with the termination board installed
inside it.
IMPORTANT
The termination board should be shipped with the grounding screw
installed. Verify this by checking the location shown in Figure 28.
The enclosure door is shipped separately. If the door has already been
attached to the enclosure back, remove it.
To mount the enclosure:
1. Using the enclosure as a template, mark the location of the four
mounting holes on the mounting surface (see Figure 28).
Figure 28. Enclosure mounting holes
Termination board
grounding screw
(must be installed)
Mounting hole
(four locations)
BAS-APG001-EN