Terminal Strips; Mounting The Metal-Enclosure Module - Trane Engineered Smoke Control System Application Manual

BAS-APG001-EN

Terminal strips

The EX2 module is shipped with terminal strips already in place
(Figure 45). If you need to replace the circuit board, you can transfer the
terminal strips to the new board without rewiring.
Figure 45. Terminal strip locations
Universal inputs
terminal strip

Mounting the metal-enclosure module

To mount the enclosure:
1. Unscrew the two screws on the front of the enclosure and remove the
cover.
2. Using the enclosure as a template, mark the location of the four
mounting holes on the mounting surface (Figure 46 on page 88).
3. Set the enclosure aside and drill holes for the screws at the marked
locations.
4. Drill holes for #10 (5 mm) screws or #10 wall anchors. Use wall
anchors if the mounting surface is dry wall or masonry.
5. Insert wall anchors if needed.
6. Secure the enclosure to the mounting surface with #10 (5 mm) screws
(not included).
Terminal strips
Binary outputs
terminal strip
Analog outputs
terminal strip
87