Installation Responsibilities - Trane R Series Installation Operation & Maintenance

Table 4 General Data RTAC Air-Cooled Condenser
Size
Condenser
Qty. of Coils
1
Coil Length
Coil Height
Number of Rows
Condenser Fans
Quantity (1)
Diameter
Total Airflow
Nominal RPM
Tip Speed
Motor SP
Min. Starting/Oper.
2
Ambient
Std Unit
Low Ambient
Weights
Operating Wt.
Shipping Wt.
Overall Dim.
Length
Width
Height
Overall Dimensions
Length
Width
Height
1. Data containing information on two circuits shown as follows: ckt1/ckt2
2. Minimum start-up/operating ambient based on a 5 mph wind across the condenser.
RLC-SVX07A-EN
General Information
70
4 4
(In) 156/156 156/156
(In) 42 42
2 2
4/4 4/4
(In) 30 30
(CFM) 71750 71750
850 850
(Ft. Min) 6675 6675
(Ea) 1.1 1.1
HCFC-22 HCFC-22
(Deg F) 15 15
(Deg F) -10 -10
(Lbs) 3384 3384
(Kg) 1535 1535
(Lbs) 3303 3303
(Kg) 1500 1500
(in)
204 204
85 85
88 88
(mm)
5176 5176
2240 2240
2223 2223

Installation Responsibilities

Generally, the contractor must install the unit per the instructions contained in
Sections 2 and 3 of this manual, including the following:
• Install unit on a flat foundation, level (within 1/4" [6.4 mm]), and strong
enough to support unit loading.
• Install any optional sensors and make electrical connections at the Unit
Control Panel.
NOTE: The standard leaving chilled water sensor is factory installed in the
evaporator leaving water outlet.
• Where specified, provide and install valves in water piping upstream and
downstream of evaporator and condenser water connections to isolate
80 90 100
4 4
168/156 168/168
42 42
2 2
5/4 5/5
30 30
77640 83530
850 850
6675 6675
1.1 1.1
HCFC-22 HCFC-22
15 15
-10 -10
3625 3686
1645 1671
3531 3584
1603 1627
204 204
85 85
88 88
5176 5176
2240 2240
2223 2223
110 125
4 4
204/168 204/204
42 42
2 2
5/5 5/5
30 30
87505 91480
850 850
6675 6675
1.1 1.1
HCFC-22 HCFC-22
15 15
-10 -10
3941 4110
1788 1865
3821 3973
1735 1804
231 231
85 85
88 88
5861 5861
2240 2240
2223 2223
9