Table of Contents
Advertisement
DND (Do Not Disturb)
mode
CLIR (hide caller ID)
Prefer Codec
only when the local system is busy. No answer means if the
incoming calls do not receive any response, they will be
forwarded to the SIP URL by the time out.
SIP URL – Type in the SIP URL (e.g., aaa@draytel.org or
abc@iptel.org) as the site for call forwarded.
Time Out – Set the time out for the call forwarding. The
default setting is 30 sec.
Set a period of peace time without disturbing by VoIP phone
call. During the period, the one who dial in will listen busy
tone, yet the local user will not listen any ring tone.
Index (1-15) in Schedule - Enter the index of schedule
profiles to control the DND mode according to the
preconfigured schedules. Refer to section 3.5.2 Schedule for
detailed configuration.
Index (1-60) in Phone Book - Enter the index of phone book
profiles. Refer to section 3.10.1 DialPlan – Phone Book for
detailed configuration.
Check this box to hide the caller ID on the display panel of the
phone set.
Select one of five codecs as the default for your VoIP calls.
The codec used for each call will be negotiated with the peer
party before each session, and so may not be your default
choice. The default codec is G.729A/B; it occupies little
bandwidth while maintaining good voice quality.
If your upstream speed is only 64Kbps, do not use G.711
codec. It is better for you to have at least 256Kbps upstream if
you would like to use G.711.
Single Codec – If the box is checked, only the selected Codec
will be applied.
Packet Size-The amount of data contained in a single packet.
The default value is 20 ms, which means the data packet will
contain 20 ms voice information.
Voice Active Detector - This function can detect if the voice
on both sides is active or not. If not, the router will do
158
Vigor2910 Series User's Guide
Advertisement
Table of Contents
