Enabling/Disabling Partitions; Defining The Arming Station; Tamper Type; Screen Saver - Visonic PowerMaxComplete Installer's Manual

4.15 ENABLING/DISABLING PARTITIONS

This menu allows you to enable/disable Partition Mode.
Partitioning allows you to divide the system into a
maximum of three independently controllable areas. Each
area can be armed / disarmed separately.
When the partition feature is disabled, zones, user codes
and features will operate the same as in a regular
PowerMaxComplete unit. When partition is enabled, menu
displays are changed to incorporate the partition feature.

4.16 DEFINING THE ARMING STATION

This mode allows you to customize the MKP-160 2way
keyprox device through the control panel and adapt the
device characteristics and behavior to the requirements of
the particular user.

4.16.1 Tamper Type

Enabling the function will enable a tamper open / close
message.
Available options are: disable and enable.

4.16.2 Screen Saver

Enabling the function will turn off the display if no key is
pressed for more than several seconds.
Available options are: disable (ac) and enable.

4.16.3 Show AC Failure

Enable/disable AC failure indication on the keyprox device.
Available options are: disable and enable.
32
Figure 4.16 – MKP-160 Configurations Flow Chart
(First display)
READY 00:00
WALK TEST
USER SETTINGS
INSTALLER MODE
ENTER CODE
[inst. code]
1. NEW INSTL CODE
15. PARTITIONING
<OK> TO EXIT
Figure 4.15 – Partitioning

4.16.4 Supervision

Define whether or not the control panel will monitor
supervision messages sent by the keyprox.
Available options are: enable and disable.

4.16.5 Exit-Entry Beeps

Define whether or not the keyprox will sound the exit and
entry beeps or whether the keyprox will sound the beeps
only when the system is armed AWAY and not when it is
armed HOME.
Available options are: off, off when home and on.
Note: Only AC versions of the MKP-160 keyprox provide
Piezo beeps.

4.16.6 Sounder Volume

Define the volume level of the sounder.
Available options are: low, mid and high.

4.16.7 Show Mem/Trbl

Define if Trouble or Memory events in the control panel will
be indicated on the LCD keyprox.
Available options are: enable and disable.
D-303983 PowerMaxComplete Installer's Guide
enable
disable