Visonic PowerMaxComplete Installer's Manual page 10

1
T h i c k c a b l e
entry: Pull out a
d e sir ed w iri ng
plastic cap (1 of 4).
Power Connection for all Countries Except USA
Power cable clamp
options
For thin For thick cable
cable (reversed clamp)
Insert power cable through the desired wiring
channel (see step 1), route it to the power supply
unit and connect its 2 wires to the power supply
terminal strip with screwdriver. Fasten power cable
by its clamp (see also step 2 - this clamp can be
reversed to fit thick/thin cable) and close the safety
cover.
Power Connection for USA Only
Connect the power adapter
to the front panel power
connector.
* Do not route wiring in this area, to enable proper closure of the control panel.
10
Power Cable Clamp Extraction
Safety
cover
1
Power
supply
Figure 3.10 - Power Cable Connection
2
Extract cable clamp
for use in the next
step.
2
Connect the power supply
output cable to the power
connector in the front
panel.
(*)
unit
D-303983 PowerMaxComplete Installer's Guide