Reporting By Sms; Conducting A Walk-Test - Visonic PowerMaxExpress User Manual

SPECIAL FUNCTIONS
Command
1 Arm AWAY
2 Arm AWAY instant
3 Arm AWAY Latchkey
4 Arm AWAY Latchkey instant
5 Arm HOME
6 Arm HOME instant
7 Disarm
8 Turn PGM ON
9 Turn PGM OFF
12 Define custom house identity
(see note)
13 Query system status
Note: House ID includes up to 16 characters, for example JOHN'S HOUSE.

Reporting by SMS

The PowerMaxExpress system can send SMS
messages to a maximum of 4 pre-selected telephone
numbers.
Example of the reported SMS messages:

JOHN'S HOME
**AWAY**

JOHN'S HOME
**DISARM**

JOHN'S HOUSE
POWERMAX: LOW BATTERY
GARAGE: LOW BATTERY

JOHN'S HOUSE
STATUS MESSAGE 01
(Event list is displayed)
Note: Status messages can be sent only to a calling
telephone whose identity number is not blocked by
the user!
Note: The PowerMaxExpress may react with a delay
to received SMS messages if a GPRS session is in
progress at the same time.
16
Individual Partition SMS Format
"AWAY <code>"
or
"AW <code>"
"AWAY INST <code>"
or
"AWI <code>"
"LATCHKEY <code>"
or
"LK <code>"
"LATCHKEY INST <code>"
or
"LKI <code>"
"HOME <code>"
or
"HM <code>"
"HOME INST <code>"
or
"HMI <code>"
"DISARM <code>"
or
"DA <code>"
"PGM ON <code>"
"PGM OFF <code>"
"HOUSE NAME <code> <house ID>"
or
"HN <code> <house ID>"
"STATUS
or
"ST <code>"

Conducting a Walk-Test

The walk-test is an indispensable operation by which
you verify that all detectors function properly, without
disturbing the neighbors with loud sirens. The test
must be performed at least once a week, and
should include all detectors in all zones.
Before performing walk-test, all the detectors must
be in normal state. Normal state is achieved when no
motion is made for at least 2 minutes.
Note: During the test period, 24-hour zones will not
cause an alarm if violated, but a fire zone will
function normally.
A typical test will take place as follows:
A. Click
B. Click the
All Partitions SMS format /
Partition Disable
"P# AWAY <code>"
or
"P# AW <code>"
"P# AWAY INST <code>"
or
"P# AWI <code>"
"P# LATCHKEY <code>"
or
"P# LK <code>"
"P# LATCHKEY INST <code>"
or
"P# LKI <code>"
"P# HOME <code>"
or
"P# HM <code>"
"P# HOME INST <code>"
or
"P# HMI <code>"
"P# DISARM <code>"
or
"P# DA <code>"
"PGM ON <code>"
"PGM OFF <code>"
"P# HOUSE NAME <code> <house ID>"
or
"P# HN <code> <house ID>"
<code>"
"P# STATUS <code>"
Or
"P# ST <code>"
. The display will read:
WALK TEST
I OK
button, the display will prompt
you for your user code:
ENTER CODE
D-303974 PowerMaxExpress User's Guide
_ _ _ _