Sierra Wireless Overdrive Pro 3G User Manual page 107

Mobile hotspot
Hide thumbs Also See for Overdrive Pro 3G:
Table of Contents

Advertisement

If
is set to Disable, the routing hardware rejects DNS requests targeting the internal
DNS Relay
DNS proxy.
The
DNS Relay
field is configurable and displayed only if
Auto, DNS Relay is enabled by default.
● DHCP Static IP Assignment List
and view the static IP assignment list. (See "DHCP Static IP Assignment List" on page 100.)
DHCP
DHCP (Dynamic Host Control Protocol) automatically assigns an IP address to each device on the
network and manages other network configuration information for devices connected to your
network. You do not need to manually configure the IP address on each device that's on your
network.
The assigned IP addresses are not permanent (as opposed to when using static IP).
Most ISPs (Internet Service Providers) use DHCP.
Normally, you should enable DHCP, in which case you must configure each device on the
network with one of the following:
TCP/IP settings set to "Obtain an IP address automatically."
TCP/IP bound to the Ethernet connection with DHCP.
If DHCP is disabled, you must configure each device on the network with:
Fixed (permanent/static) IP address.
DNS server addresses (provided by your service provider).
Enabling DHCP
1.
Log in to the home page.
2.
Click
Advanced Settings > Router > LAN
3.
Next to
DHCP Server
Configuring DHCP
To configure DHCP settings, DHCP must be enabled (
DHCP Server
).
You can set the following DHCP settings in
● DHCP IP Address Range
available for the device to dynamically (that is, not permanently) assign to computers
connected to it.
The start address must be 192. 1 68.0.10 or above.
The ending address must be 192.168.0.50 or below.
● DHCP Lease Time
— This is the amount of time, in minutes, a computer can use its assigned IP
address before it is required to renew the lease. After this time is up, the computer is
automatically assigned a new dynamic IP address.
— You can assign a permanent IP address to a MAC address,
.
, select
Enable
.
Advanced Settings > Router > LAN
— This is the starting and ending address of the range of IP addresses
DNS Mode
is Manual. If
Advanced Settings > Router > LAN >
:
DNS Mode
is
Settings
99

Advertisement

Table of Contents
loading

Table of Contents