Locating The System Board Jumper - NEC POWERMATE ENTERPRISE - 10-1997 Manual

Jumpers are set correctly at the factory for your
configuration.
If your system requires a jumper change, change
only the setting for that condition. Otherwise, keep
the jumpers at their factory settings.

LOCATING THE SYSTEM BOARD JUMPER

The following figure shows the location of the configuration
jumper on the system board. See the following table for
jumper setting information. See "Changing Jumper
Settings" for information on how to change a jumper
setting.
The system power must be off before changing a
jumper setting.
6-2 Setting System Board Jumpers
!
CAUTION
!
WARNING