Monitoring Configuration Submenu; Table 5-7. Console Redirection Features - NEC Express5800/320Ma Technical Reference Manual

Table 5-7. Console Redirection Features

Feature
Com Port Address
Baud Rate
Console Type
Flow Control
Console Connection
Continue C.R. After
POST

Monitoring Configuration Submenu

Select Monitoring Configuration from the Advanced menu to display the Monitoring
Configuration submenu, which is shown in
make your selections and exit to the Main menu.
Options
Enabled
Disabled
On-board COM A
On-board COM B
9600, 19.2K, 38.4K,
57.6K, 115.2K
VT100
VT100, 8bit
PC-ANSI, 7bit
PC ANSI
VT-UTF8
VT100+
XON/XOFF
CTS/RTS
None
Direct
Via modem
On or Off
Figure
ftServer Setup Menus
Description
Enables or disables the use of the
port on the motherboard. Disabled
by default.
Redirects the console to Serial
Port 1 or 2. If Console Redirection
is enabled, this address must
match the settings of Serial Port 1
or 2.
Sets the specified baud rate. 9600
by default.
Specifies the type of console. PC
ANSI by default.
Select XON/XOFF to enable flow
control, which uses the XON
XOFF software protocol.
XON/XOFF by default.
CTS/RTS (Clear to Send/Ready to
Send) enables the hardware
handshake protocol.
Specifies that the console
connects to the system either
directly or by a modem. Direct by
default.
Enables console redirection after
the operating system has loaded.
5-8. Use the legend bar keys to
BIOS Setup 5-15