NEC Express5800/320Ma Technical Reference Manual page 36

ftSMC Component Properties
Table 3-1. ftSMC System Inventory Component Properties (Continued)
Property
ModelDescription or
ModelDesc
ModelName
Modem Check Interval
Modem Country Code
Modem Post-Init Commands
Modem Pre-Dial Commands
MTBF: Current
MtbfFaultLimit
MTBF: NumberOfEvents
MTBF: Threshold
MTBF: TimeOfLastEvent
MTBF: TimeOfLastFault
MTBF: Type
Name
3-12 Express5800/320Ma: Technical Reference Guide
Description
The VTM board description.
The Express5800/320Ma system name as stored in the system ID
PROM. For VTMs, the VTM OEM product number.
The number of seconds that the system waits between checking
that the modem attached to the system is functional and checking
that a dial tone exists on the phone line. If this value is set to zero,
modem checks are disabled. The default is 3600 seconds (1 hour).
Telephone calling code for the country where the modem is located
(for instance, 1 = USA, 44 = United Kingdom). Select the country
from the drop-down list.
Contains additional modem initialization string commands that are
sent to the SMM modem after the default initialization string is sent.
Contains additional modem dial commands that are sent to the
SMM modem immediately prior to the sending of a dial command.
Current MTBF in seconds. A value of unknown (0) indicates that the
device has not failed enough times for an MTBF to have been
calculated.
Defines the number of times certain errors can occur before the
system sends threshold events that generate alarms.
Total number of faults for a component.
Threshold, in seconds, below which the component will not be
automatically brought back into service when it fails. The default is
600 seconds, and the range is 600 seconds to 4,294,967,295
32
(2 -1) seconds.
Date and time of the last fault on a component.
Time at which the device last failed.
Defines how the threshold value is used when a device fails.
Normally Type is set to Use Threshold, which indicates that the
threshold value is used to determine whether to automatically bring
the device back into service. The NEC Technical Support can set it
to Never Restart or Always Restart.
In ASN, the name or designation of each ASN Configuration node.
In relation to the SATA embedded adapter, defines the label by
which the object is known. When subclassed, the Name property
can be overridden to be a Key property.