NEC Express5800/320Ma Technical Reference Manual page 76

ftServer Setup Menus
Table 5-5. I/O Device Configuration Features (Continued)
Feature
Base I/O address
Serial Port 1
Connection
Serial Port 2 Sharing
NumLock
Keyboard repeat rate
Keyboard repeat delay
5-12 Express5800/320Ma: Technical Reference Guide
Options
3F8 IRQ 4
2F8 IRQ 3
3E8 IRQ 4
2E8 IRQ 3
Internal Modem
Serial Connector
Enabled, Disabled
Auto (default)
On
Off
30/sec
26.7/sec
21.8/sec
18.5/sec
13.3/sec
10/sec
6/sec
2/sec
1/4 sec
1/2 sec
3/4 sec
1 sec
Description
Sets the base I/O address for the
serial port.
Specifies whether Serial Port 1 is
used by the ASN modem or is
available for general use.
Do not select Internal Modem for
for Serial Port 1 if the system
contains VTMs.
If enabled, the BMC can use Serial
Port B during BIOS power-on
self-test and also when the
operating system is running.
If disabled, the BMC can use Serial
Port 2 only during BIOS power-on
self-test.
NumLock is enabled at system boot
if a numeric keypad is detected.
NumLock is enabled at system
boot.
NumLock is disabled at system
boot.
Sets the number of times per
second the system repeats a
keystroke while the user
continuously presses the key.
Sets the delay time that the system
allows between the moment a key
is first pressed and the moment that
the system repeats the keystroke.