Chapter 5 - Emonitor/Alarm Notification - Toshiba Strata CIX Programming Manual

eMonitor/Alarm Notification
Alarm Notification (AN) sends a notification of a system alarm condition. The notification can be
sent over a network connection to an eMonitor system, other application and, optionally, to a feature
button on a telephone.
eMonitor configuration capacity:
•
Each CIX system can send alarm trap messages to up-to 11 eMonitor servers.
•
Each eMonitor server can monitor an unlimited number of CIX systems.
•
Each eMonitor server can send email alerts to an unlimited number of mail boxes.
•
Each eMonitor can send emails to unique email addresses for each CIX system.
The alarm notification is SNMP Trap data that can be sent to as many as 11 different IP addresses.
Up to eight stations can have a button programmed as an Alarm Indicator. There are three categories
of alarms: ISDN, T1, and System Resources.
This section provides a description of Alarm types the Strata CIX system sends to eMonitor and
describes how eManager R5.0 or later is used to set up the CIX system to send alarm notifications
to the eMonitor application.
There are two types of SNMP messages sent to the external, eMonitor, PC or Server.
•
Alarm Notification when an error condition occurs.
•
Alarm Summary Condition Summary, containing the alarm buffer status, is sent every 10
minutes whether an alarm has occurred or not. This summary includes the Alarm Buffer status.
The table below shows the alarms that can be monitored by the Alarm Notification feature. The list
is shown by alarm type.
ISDN
ISDN Loss of signal (PRI)
ISDN Frame Sync Failure (PRI)
ISDN AIS (PRI
ISDN-U Maintenance Mode (BRI)
ISDN-U EOC Maintenance Mode
(BRI)
ISDN-U ACT (BRI)
ISDN-U AIB (BRI)
Strata CTX Application Implementation Vol 3
T1
T1 Yellow Alarm Expansion Cabinet Power Failure
T1 Blue Alarm Cooling Fan Failure (CIX200 only)
IPU Card Data Set Problem
T1 Frame Sync Failure
(LIPU or BIPU-M DSP)
SMDR Memory Buffer Full
CTI Link Down (Attendant Console, ACD,
External Stratagy System)
SMDR Link Down (LAN / RS232c)
SMDI Link Down (LAN only -
The SMDI RS232c port is not monitored)
10/07
System Resources
5
5-1