Advertisement
Available languages
Available languages
E
2.2 - Enter a menu option. Once the LED displays the color of
N
the menu item that is needed, pull and hold the trigger for two seconds.
G
2.3 - Current Value. Upon entering a menu item, the LED will begin
to flash red. The flashes represent the current menu value. The current
L
value will be flashed twice with a short pause between the number of
I
flashes. If a new value is not entered before the end of the second value
display, the electronics will automatically return to the main menu.
S
2.4 - Enter a new value. At any time while the menu is flashing the
H
LED in accordance with its current value, a new value can be entered by
pulling and releasing the trigger. Each pull and release of the trigger will
count as a 1 when entering the new value. Example: To enter a number
5, pull and release the trigger five times. Once the user is done entering
the value, release the trigger.
2.5 - Successful update confirmation. Once the user has en-
tered a new value for a menu item, the LED will flash red/orange/green
twice to signify an acceptable value has been entered. The
electronics will then return to the main menu. If an unacceptable value
has been entered, the LED will quickly flash red and return to the main
menu. The value of the menu item will not be updated if this happens.
2.6 - Power off. Once a menu item has been changed, the user
must power-off the electronics before the change will take effect. Hold
the power button for 2 seconds. The LED will change to solid red. Re-
lease the power button and the electronics will power off.
2.7 - Optional: Factory settings reset. A reset to factory
settings can be accomplished by pressing and holding the power button
for 10 seconds. The board will appear to power on normally, but after 10
seconds, the LED will flash red/orange/green twice, then the board will
power-off. All factory settings are reset at this point.
Troubleshooting
PROBLEM: The LED light does not light when you push
the power button to turn ON the E-Grip.
1. Battery must be installed. Check
that the battery is installed.
2. Battery may be disconnected.
Check the battery clip con-
nection.
3. Battery may be bad. Check the
battery, replace if bad.
4. Wire may be disconnected from
the battery clip. Inspect the wire
connections to the battery clip at
(A) and (B).
8-E
A
B
Advertisement
