Advertisement
Available languages
Available languages
Special Firing Mode - (Factory Default Value = 2 Safe Full-auto) The
Special Firing Mode menu item is used to change the default Special Firing
Mode. The value and corresponding Special Firing Mode are listed below.
1. Safe Three-shot Burst
2. Safe Full-auto (factory default)
3. Auto-Response
4. Turbo Mode
5. Semi-automatic
This menu item can only be updated with the values of 1-5.
Step 1 - Accessing Advanced User Programming
1.1 - Before attempting to Access the Advanced User
Programming, unload your marker and remove the air/CO2 supply
(follow the instructions in STEP 1: on pages 1-E and 2-E). Do not attempt
to perform Advanced User Programming on a marker that is under pressure.
1.2 - Power off. To begin the Advanced User Programming, make
sure the power is off. If the power is on, press and hold the power button
for 2 seconds. The LED will change to a solid red color. The E-Grip will
power down when the power button is released.
1.3 - Place Safety Selector in the fire position (F or FA).
1.4 - Pull the trigger. Pull and hold the trigger back.
1.5 - Power on. Press and hold the power button down for 2 sec-
onds. The E-Grip will appear to power on normally. Release the power
button when the LED turns green.
1.6 - Continue holding the trigger. Continue to hold the trigger
back for 5 seconds. After 5 seconds, the LED will change to a solid red
color.
1.7 - Release the trigger. When the LED changes to the solid
red color, release the trigger. The E-Grip is now in the main menu of the
Advanced User Programming.
Step 2 - Choosing a menu item
The four menu items contained in the Advanced User Programming menu
are Dwell, Debounce, Rate-of-fire, and Special Firing Mode. Each of these
menu items has a corresponding color code as follows.
1. Solid Red - Dwell
2. Solid Green - Debounce
3. Flashing Green - Rate of fire
4. Alternating Red/Green - Special Firing Mode
2.1 - Cycling through the menu. To cycle through the menu, pull
and release the trigger. Each time the trigger is pulled and released, a differ-
ent color will be displayed on the LED in accordance with the list above.
7-E
E
N
G
L
I
S
H
Advertisement
