Lower Receiver Disassembly/Assembly; Trigger Disassembly/Assembly; E-Grip Trigger Assembly; Inside The E-Grip - Tippmann A-5 Owner's Manual

E
7. Insert and twist the Barrel Adapter assembly clockwise to reinstall.
N
8. Insert the Front Sight, with its slot facing the rear of the marker, into the top front of the
G
Receiver. Insert the Front Sight screw (11) to hold in place.
L
9. Install the Front Grip to the upper Receiver. Secure with lower Screw (11) and the
I
Screw (52) and Washer (51) inside the bottom of the grip.
S
10. Make sure all Receiver Screws (11) are tight (do not overtighten and strip threads).
H

Lower Receiver Disassembly/Assembly

These instructions also apply for the E-Grip lower Receiver.
1. Follow the
lower Receiver is removed from the marker.
2. Remove the Trigger Assembly from the lower Receiver.
a. Wiggle the Selector Switch and pull straight out from the left side of the lower
Receiver.
b. Lift the Trigger Assembly out of the lower Receiver.

Trigger Disassembly/Assembly

1. Lay
Trigger
2. Pull the
Left Trigger Plate
Trigger Plate
(36) or the black
Pins
Trigger plate. Replace only if necessary.
3. Inspect remaining parts for damage; replace
parts only if necessary.
4. When finished, reinstall Left Trigger Plate back
onto the Right Trigger Plate.

E-Grip Trigger Assembly

The E-Grip parts are shown in position, located on
the Right Trigger Plate (35). Parts specific to the
E-Grip are shown in bold. These bolded parts are not
shown in the parts diagram (pages 24-25). The red
dot on the Magnet must be visible on the side shown
to operate properly. The Sear Spring has tension
specifically designed for the E-Grip. The E-Grip will
not operate properly if any other spring is used here.

Inside the E-Grip

1. Remove the Air Supply Adapter (ASA) bolts.
Remove three Screws (32) and one Screw (34)
to separate the E-Grip Receiver halves.
2. Inspect all parts for damage; replace parts only
if necessary.
3. For reassembly, make sure the Trigger Guard,
2 ASA nuts, and Electronics (with Spacer and
Armature in place) are positioned in the right
grip half as shown (Figure 22).
4. Visually inspect battery wires for damage or
breakage where they connect to the Electronics
board and also at the battery connector. Repair
or replace the Electronics board if necessary.
A-5 Marker Disassembly/Reassembly Instructions
Assembly flat on workbench.
(42) from the
(35). Do not remove the four
Dowel Pin
40
Right
Dowel
(37) from the Right
Figure 18: Trigger Assembly
40
TA10021
Trigger
Figure 19: E-Grip Trigger Assembly
Trigger
Guard
Gasline
Figure 20: E-Grip lower Receiver
20
(page 17) until the
36
37
39
41
36
TA10073 Sear
35
02-88 Sear
37
Spring
TA10072 Magnet
Trigger
Assembly
Selector Switch
Lower
Receiver
32
34
ASA Bolts
38
35
ASA