Fostex D-160 Owner's Manual page 55

Playback (Refer to "3-1. Basic recording/playback" for details.)
7
. Press the RECORD TRACK select key for the track in ready mode so that the track
becomes "safe."
The track LED will be turned off.
8
. Press the REWIND button while holding down the STOP button to locate the top of the
Program (ABS 0) (LOCATE ABS 0).
9
. Press the PLAY button.
Playback will start. Adjust the TAPE IN input level from the mixer.
The maximum total recording time of all nine Programs equals the available recording
time of the hard disk. For example, if you use the optional Model 9041 (1.3GB
removable hard disk cartridge), the available recording time is about 15 minutes
(with a sampling rate of 44.1kHz, 16 tracks recording). If you have recorded 5 minutes
of data in Program 1, you can record 10 minutes for the total time of another Programs.
That is, you can record data totalling 15 minutes, regardless of whether you use up all
Programs or you record only one Program. Therefore, the remaining recording time
is obtained by subtracting the sum of the recorded time for all recorded Programs
from the initial total available time.
This remaining time is indicated as the REMAIN time when you press the DISP SEL
key. Be sure to watch this time when you are recording multiple Programs.
Data with a sampling rate of 48kHz uses more hard disk space than data with a sampling
rate of 44.1kHz. Therefore, the available recording time is shorter for 48kHz data.
* Refer to "2-1. Setting a Program" and "2-2. Program Change" for more information
on Programs.
* Refer to "2-4. Setting a sampling rate" for more information on sampling rates.
D-160 Owner's Manual (Recording /Playback)
<Note>
<Note>
55